* Restore state for ZHA OnOff binary sensors
* Let `Motion` extend `Opening`
`Motion` is just a specified version of `Opening` that only changes the device class for some motion sensors.
Since we have more "special code" in the OnOff/Opening sensor now, we also want to make sure that gets applied to `Motion` binary sensors.
* Improve comment and type
* Add test to verify that binary sensors restore last HA state
* Migrate old ZHA IasZone sensor state to zigpy cache
* Use correct type for ZoneStatus
* Test that migration happens
* Test that migration only happens once
* Fix parametrize
* Adding binding of IKEA Matter Switch cluster
IKEA Symfonisk Gen 2 is using Matter ZCL Switch command but on manufacture cluster then its not supported in ZVL R8 that need being bond for sending the commands to the coordinator.
* Update manufacturerspecific.py
* Update manufacturerspecific.py
Delete not needed function `@registries.BINDABLE_CLUSTERS.register(0xFC80)`
* Construct binary sensor state from zigpy cache (WIP)
* Workaround zha-quirks issue where "MotionWithReset" quirks don't update attribute cache (WIP)
zha-quirks currently has an issue where the ZONE_STATE attribute is updated (when the zone_STATUS changes).
https://github.com/zigpy/zha-device-handlers/pull/2231 is a proper fix for this.
For now, we just update the attribute cache when we get the "zone status update notification" command.
This wasn't noticed before, as the "attribute report signal" was sent from the `cluster_command()` method and the used the provided attribute (in the signal) to update the `_state` value in the binary sensor class.
As we just tell HA to write state again when we get an attribute report now, the ZONE_STATUS attribute is read now (and needs to be correct).
* Use parse() method of main class for IasZone entity (with stripped bits)
* Change wording in comment, remove explicitly sending attr signal
(This comment should be removed/changed later anyway)
* Remove note
* Get zone_status attribute id with zigpy
* Remove `security.` prefix for `IasZone` import
`AceCluster` was already directly imported and `IasZone` is too now for getting the attribute id
* Store full zone status attribute in cache
* Check that non-alarm bits are ignored in IasZone sensor test
* Re-enable occupancy binary sensor test
This test seems to work fine and I don't see any reason why it was commented out for a while
* Fix cached read mix-up for `zone_status`/`zone_state`
This allows cached reads for `zone_state` (enrolled or not), but forces a new read for `zone_status` (alarm or not).
* Rename `zha.api` to `zha.websocket_api`
* Implement a ZHA network settings API
* Use the enum name as the radio type
* Don't filter out ignored config entries
* [WIP] Start unit tests
* Add unit tests
* Rename ZHA websocket API module in `.coveragerc`
* Rename `api` to `websocket_api`
* Increase test coverage to 100%
* Clean config flow entries with trailing whitespace
* Rewrite the config entry at runtime, without upgrading
* Skip intermediate `data = config_entry.data` variable
* Perform a deepcopy to ensure the config entry will actually be updated
* Expose the Yellow-internal radio and multi-PAN addon as named serial ports
* Remove the serial number if it isn't available
* Use consistent names for the addon and Zigbee radio
* Add `homeassistant_hardware` and `_yellow` as `after_dependencies`
* Handle `hassio` not existing when listing serial ports
* Add unit tests
* Use a set for config entries task tracking
* Allow adding background tasks to config entries
* Add tests for config entry add tasks
* Update docstrings on core create task
* Migrate roon and august
* Use in more places
* Guard for None
